Technical data

1 Hardware Preparation and Installation

MVME51005E Single Board Computer Installation and Use (6806800A38B)

– Insert the threaded end into the standoff hole at each corner of the

MVME5100.

– Thread the locking nuts into the standoff tips and tighten.

5. Place the PMCspan on top of the MVME5100. Align the mounting holes in each corner

to the standoffs and align PMCspan connector P4 with MVME5100 connector J25.

Figure 1-4. PMCspan-002 Installation on an MVME5100

6. Gently press the PMCspan and MVME5100 together and verify that P4 is fully seated

in J25.

7. Insert four short screws (Phillips type) through the holes at the corners of the PMCspan

and into the standoffs on the MVME5100. Tighten screws securely.

Secondary

PMCspan

The PMCspan16E-010 PCI expansion module mounts on top of a PMCspan16E-002 PCI

expansion module. To install a PMCspan-010 on your MVME5100, perform the following steps

while referring to the figure on the next page:

2081 9708

PMCspan

MVME5100