Technical data

MVME51005E Single Board Computer Installation and Use (6806800A38B)
1 Hardware Preparation and Installation
4
Refer to the section titled Jumper Settings on the next page for additional information.
Note
1. Write protects only outer two 8K boot sectors. Refer to Flash Memory on page 40 for
an complete explanation.
Jumper Settings
Prior to performing the installation instructions, you must ensure that the jumpers are set
properly for your particular configuration. For example, if you are using an IPMC761/MVME761
or IPMC712/MVME712 combination in conjunction with the MVME5100, you must reset the
jumpers for the SBC mode (jumpers J4, J6, J10, J17 and J20). These are factory configured for
the PMC mode. Verify all settings according to the previous table and follow the instructions
below if applicable.
J7 Flash Memory Selection Pins 1, 2 for Soldered Bank A Sockete
d
Bank B
Pins 2, 3 for Socketed Bank B
J10, J17 Ethernet Port 2
Selection
(see also J4)
For Front Panel Ethernet Port 2:
Pins 1, 3 and 2,4 on Both Jumpers
Front
Panel
Ethernet
Port 2
For P2 Ethernet Port 2:
Pins 3, 5 and 4, 6 on Both Jumpers
(set for SBC mode)
J15 System Controller
(VME)
Pins 1, 2 for No SCON
Auto
SCON
Pins 2, 3 for Auto SCON
No Jumper for ALWAYS SCON
J16 Soldered Flash
Protection
Pins 1, 2 Enables Programming of
Flash
Flash
Prog.
Enabled
1
Pins 2, 3 Disables Programming of
the upper 64KB of Flash
Table 1-1. Manually Configured Headers/Jumpers (continued)
Jumper Description Setting Default