Manualshelf

Technical data

ManualsBrandsEmerson ManualsComputer equipmentMVME51005E
11121314151617181920
MVME51005E Single Board Computer Installation and Use (6806800A38B)
xv
About This Manual
The MVME51005E Single Board Computer Installation and Use provides the information you
will need to install and configure your MVME51005E Single Board Computer. It provides
specific preparation and installation information and data applicable to the board
. The
MVME51005E will hereafter be referred to as the MVME5100.
The MVME5100 is a high-performance VME single board computer featuring the PowerPlus II
architecture with a choice of processors—either the MPC7410 with AltiVec
™
technology for
algorithmic intensive computations or the low-power MPC750.
As of the printing date of this manual, the MVME5100 is available in the configurations shown
below. Note: all models of the MVME5100 are available with either VME Scanbe front panel or
IEEE 1101 compatible front panel handles.
Model Number Description
450MHz MCP750 Commercial Models
MVME51005E-016x 450MHz MCP750, 512MB ECC SDRAM, 17MB Flash and 1MB L2
cache.
400 and 500 MHz MPC7410 Commercial Models
MVME51105E-216x 400MHz MPC7410, 512MB ECC SDRAM, 17MB Flash and 2MB
L2 cache.
MVME51105E-226x 500 MHz MPC7410, 512MB ECC SDRAM, 17MB Flash and 2MB
L2 cache
MVME712M Compatible I/O
IPMC7126E-002 Multifunction rear I/O PMC module; 8-bit SCSI, Ultra Wide SCSI,
one parallel port, three async and one sync/async serial port.
MVME712M6E Transition module connectors: One DB-25 sync/async serial port,
three DB-25 async serial ports, one AUI connector, one D-36
parallel port, and one 50-pin 8-bit SCSI; includes 3-row DIN P2
adapter module and cable.
MVME761 Compatible I/O
IPMC7616E-002 Multifunction rear I/O PMC module; 8-bit SCSI, one parallel port,
two async and two sync/async serial ports.
MVME7616E-001 Transition module: Two DB-9 async serial port connectors, two HD-
26 sync/async serial port connectors, one HD-36 parallel port
connector, and one RJ-45 10/100 Ethernet connector; includes 3-
row DIN P2 adapter module and cable (for 8-bit SCSI).
MVME7616E-011 Transition module: Two DB-9 async serial port connectors, two HD-
26 sync/async serial port connectors, one HD-36 parallel port
connector, and one RJ-45 10/100 Ethernet connector; includes 5-
row DIN P2 adapter module and cable (for 16-bit SCSI); requires
backplane with 5-row DIN connectors.
SIM232DCE5E or DTE EIA-232 DCE or DTE Serial Interface Module.