Technical data

Transition Module

MVME4100 Single Board Computer Installation and Use (6806800H18D)

There are two sets of ACT and SPEED LEDs, one set for each Ethernet connector. They are

described in the next table.

5.5.1 MVME7216E PMC I/O Module (PIM) Connectors (J10, J14)

PMC Host I/O connector J10 routes only power and ground from VME P2. There are no Host I/O

signals on this connector. The MVME4100 routes PMC I/O from J14 of PMC Slot 1 to VME P2

rows A and C. The MVME7216E routes these signals (pin-for-pin) from VME P2 to PMC I/O

Module connector J14. See Table 5-6 and Table 3-8 for the pin assignments.

Table 5-5 Transition Module LEDs

LED Function

ACT Activity for Ethernet or Gigabit E Ethernet connector

SPEED 10/100/1000Mb/s of Ethernet connectors

Table 5-6 MVME721 Host I/O Connector (J10) Pin Assignments

Pin Signal Signal Pin

1 No Connect No Connect 2

3 No Connect No Connect 4

5+5V No Connect 6

7 No Connect No Connect 8

9 No Connect +3.3V 10

11 No Connect No Connect 12

13 GND No Connect 14

15 No Connect No Connect 16

17 No Connect GND 18

19 No Connect No Connect 20

21 +5V No Connect 22

23 No Connect No Connect 24

25 No Connect +3.3V 26

27 No Connect No Connect 28