Technical data

Hardware Preparation and Installation

MVME4100 Single Board Computer Installation and Use (6806800H18D)

4. Slide the edge connector of the PMC module into the front panel opening from

behind and place the PMC module on top of the base board.

The four connectors on the underside of the PMC module should then connect

smoothly with the corresponding connectors on the MVME4100.

5. Insert the four short phillips-head screws (provided with the PMC) through the

holes on the bottom side of the MVME4100 and the PMC front bezel and into rear

standoffs.

6. Tighten the screws. Refer to Figure 2-6 on page 52.