Technical data

Connecting to Peripherals Hardware Preparation and Installation
MVME3100 Single Board Computer Installation and Use (6806800G36A)
25
To remove the board from the chassis, press the red locking tabs (IEEE handles only) and
reverse the procedure.
1.6 Connecting to Peripherals
When the MVME3100 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
Figure 1-1 on page 20 shows the locations of the various connectors while Tabl e 1-7 and Ta ble
1-8 list them for you. Refer to Chapter 5, Pin Assignments for the pin assignments of the
connectors listed below.
Table 1-7 MVME3100 Connectors
Connector Function
J4 PMC expansion connector
J11, J12, J13, J14 PCI mezzanine card (PMC) slot 1 connector
J21, J22, J23 PCI mezzanine card (PMC) slot 2 connector
J24 Boundary scan header
J25 COP header
J27 USB connector
J28 Front panel sATA connector
J29 Planar sATA connector
J30 Planar sATA power connector
J41B 10/100/1000Mb/s Ethernet connector
J41A COM port connector
P1, P2 VME backplane connectors
Table 1-8 MVME721 Rear Transition Module Connectors
Connector Function
J1A, J1B, J1C, J1D COM port connectors
J2A 10/100/1000Mb/s Ethernet connector
J2B 10/100Mb/s Ethernet connector
J10 PIM power/ground
J14 PIM I/O
P2 VME backplane connector