Technical data

MVME3100 Single Board Computer Installation and Use (6806800G36A)

Hardware Preparation and Installation Installing Hardware

The RTM EEPROM address switches must be set for address $AA in order for this device to be

accessible by MotLoad.

1.5 Installing Hardware

Procedure

Use the following steps to install the MVME3100 into your computer chassis.

1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an

electrical ground (refer to Unpacking Guidelines). The ESD strap must be secured

to your wrist and to ground throughout the procedure.

2. Remove any filler panel that might fill that slot.

3. Install the top and bottom edge of the MVME3100 into the guides of the chassis.

4. Ensure that the levers of the two injector/ejectors are in the outward position.

5. Slide the MVME3100 into the chassis until resistance is felt.

6. Simultaneously move the injector/ejector levers in an inward direction.

7. Verify that the MVME3100 is properly seated and secure it to the chassis using the

two screws located adjacent to the injector/ejector levers.

8. Connect the appropriate cables to the MVME3100.

$A2 001 OFF ON ON

$A4 010 ON OFF ON

$A6 011 OFF OFF ON

$A8 100 ON ON OFF

$AA (Factory) 101 OFF ON OFF

$AC 110 ON OFF OFF

$AE 111 OFF OFF OFF

Table 1-6 EEPROM Address Settings (continued)

Device Address A(2:0) SW1 SW2 SW3

Product Damage

Only use injector handles for board insertion to avoid damage/deformation to the

front panel and/or PCB. Deformation of the front panel can cause an electrical short

or other board malfunction.