Specifications

consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is
operating.
Wi-Fi
Default Value: Off (Wired)
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off (Wired)": Wired LAN connection
Wi-Fi Setup
Default Value: –
You can configure wireless LAN settings by pressing ENTER when
"Start" is displayed.
Wi-Fi Status
Default Value: –
The information of the connected access point will be displayed.
"SSID": SSID of the connected access point.
"Security": Security method of the connected access point.
"Signal": Signal strength of the connected access point.
"Status": Status of the connected access point.
MAC Address
Default Value: –
This is the MAC address of the AV receiver.
This value is specific to the component and cannot be changed.
DHCP
Default Value: Enable
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
If selecting "Disable", you must set "IP Address", "Subnet Mask",
"Gateway", and "DNS Server" manually.
IP Address
Default Value: –
Displays/Sets the IP address.