Specifications

Remote Controller
The remote controller does not work
Before operating this unit using remote controller, be sure to press RCV.
Make sure that the batteries are installed with the correct polarity.
Install new batteries. Do not mix different types of batteries, or old and
new batteries.
Make sure that the remote controller is not too far away from the unit, and
that there is no obstruction between the remote controller and the remote
control sensor of the unit.
Make sure that the unit is not subjected to direct sunshine or inverter-type
fluorescent lights. Relocate if necessary.
If the unit is installed in a rack or cabinet with colored-glass doors or if the
doors are closed, the remote controller may not work reliably.
Make sure you have selected the correct remote controller mode.
When using the remote controller to control other manufacturers’ AV
components, some buttons may not work as expected.
Make sure you have entered the correct remote control code.
Make sure to set the same ID on both the unit and remote controller.
Operating other Onkyo component by using a RI remote control code is
not available
Make sure that the Onkyo component is properly connected with RI
cable. When RI cable is used for connection, make sure to connect
analog audio (RCA) cable as well. (Connecting only an RI cable will not
be enough.)
Make sure you have selected the correct remote controller mode.
Make sure that the input display is correctly set.
Input the RI remote control code again.
When the RI remote control code is input, point the remote controller at
remote control sensor of the unit.
Can not operate Onkyo components (ones without RI connection) and
components of other makers
Make sure that the connection with other components is correct.
Input a correct remote control code again. If there are several codes, try
each code.
Make sure that the remote controller mode is correctly selected.
Operate the remote controller by setting toward the light receiving section
of each component.
Some components may not start the operation.
Troubleshooting