User manual

Firmware Updates
23
Once the last file is downloaded, the screen below right will appear.
Repeat Steps 2 through 4 to change
the baud rate back to 9600 bps as
show in the illustration below right.
After the communication settings are
adjusted, hit the Enter key on your
keyboard. The screen at right will
appear.
You can also cycle power on the Open-
Comms NIC-485. This action will also
initiate communication and provide
information on current revision sta-
tus. Once the “Initializing Net-
work…” line appears, hit the Enter
key on your keyboard.
Select X and the card will reboot.
To ensure that the latest firmware is
downloaded to the OpenComms
NIC-485, cycle power by removing
and restoring the power connection at
TB3. The information below will
appear.
NOTE
The information above, such as version values and numbers,
will change as Liebert releases new firmware.