User manual

System Configuration

Change User Name / Password

This section allows users to set or change the default user name and

password.

• Default user name is “Liebert” (case sensitive).

• Default password is “Liebert” (case sensitive).

Firmware Updates Menu

The Firmware Update Menu is intended for Liebert service personnel only. No

user configurable parameters are accessed in this selection. If entered, to escape,

power must be cycled on the card.

Factory Settings Menu

The Factory Settings Menu displays the manufacture date, serial

number and MAC address of the card. These parameters are read-

only. Once all parameters have been entered, press Escape to return

to the Main menu; then press x to save configuration, exit and reboot

to enable the new configuration. All parameters are stored in non-vol-

atile flash memory. Pressing q after Escape will abort all changes.

Neither selection is case-sensitive.

Auxiliary Communication

The Auxiliary Communication Menu allows the user to set up the

parameters necessary for Modbus communication. The user can

enable / disable the Modbus sessions as well as assign the slave ID.

Q. <q> will abort all changes.

X. <x> will save configuration changes.

Once all parameters have been entered, press <escape> to return

to the Main menu; then press exit and reboot using the new con-

figuration. All parameters are stored in non-volatile flash mem-

ory.

Neither selection is case-sensitive.