User manual

Installation
6
5. After the communication settings are adjusted, press the Enter
key on your keyboard. This will initiate communication with the
card and Figure 3 should appear.
Figure 3 NIC-485 main menu in HyperTerminal
(You can also cycle power on the OpenComms NIC-485. This will
also initiate communication and provide information on current
revision status.)
6. When the message “Initializing Network…” appears, hit the
Enter key on your keyboard. (Additional network information
may appear)
!
CAUTION
Cycling power on either the 7200 or the HiPulse UPS is not
recommended unless the unit is in bypass mode. Consult the
UPS user manual for further instructions.