User manual

Network Settings
17 Liebert
®
IntelliSlot
®
Web Cards
5.1.2 Boot/IP Settings (IS-WEBCARD Only)
The Boot/IP Settings Menu is used to set parameters for network access to
the Web card. Consult your network administrator for these settings.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
1. Choose IP Network Settings from the Main Menu, then Boot/IP
Settings.
2. Select an option to change—for example, Speed/Duplex, then enter settings according to the
following guide.
Table 11 Boot/IP settings range
(IS-WEBCARD only)
Parameter Description & Valid Settings*
Speed/
Duplex
Speed and duplex configuration of the Ethernet port.
Note: Typically, the value should be set to Auto; check with your network administrator
IPv4 Boot
Mode
Method the card uses to configure an IPv4 address.
• Static: Directly specifies the network parameters
• BootP - Older mechanism for central management of network addresses and device
configuration
• DHCP - Allows central management of network addresses
• Unconfigured - Do not configure an IPv4 address
IPv4 Address Internet protocol version 4 address for the interface
Subnet Mask Network mask for the address which divides your network into manageable segments
Default
Gateway*
IPv4 address of the gateway for network traffic for other networks or subnets.
*
The value should be obtained from your network adminsitrator.
Acceptable values consist of 4 numbers, ranging from 0 to 255, separated with a *.* character. As
an example, “10.0.0.1”
IPv6 Boot
Mode
Method the card uses to configure an IPv6 address.
• Static + Auto: Directly specifies the network parameters and allows central management of
network addresses and device configuration
• Auto - Allows central management of network addresses and device configuration
• Unconfigured - Provides support for the link-local IPv6 address only
IPv6 Address Internet protocol version 6 address for the interface
Prefix Length
Prefix length for the address divides your network into manageable segments.
Acceptable values range 0-128.
Default
Gateway**
IPv6 address of the gateway for network traffic desired for other networks or subnets.
**
The value should be obtained from your network adminsitrator.
Acceptable IPv6 values conist of 8 hexidecimal numbers ranging from 0 to ffff, separated by
colons. A double colon can be used to eliminate the need to list consecutive zeroes within the
address. As an example “2001:0db8::8a2e:030:7334”
Boot/IP Settings Menu
----------------------
1: Speed/Duplex Auto
2: IPv4 Settings
3: IPv6 Settings
4: Ping Settings
<ESC>: Cancel menu level
Please select a key ?>