User manual

NIC Setup and Testing
25
6.0 NIC SETUP AND TESTING
The NIC has a specific setup that must be in place before the card will
function properly. There are jumpers on the board that must be in the
correct locations. The positions of these jumpers are numbered on the
board itself. A small triangle silk screened on the board represents
pin 1 for each set of pins to which jumpers may be applied.
6.1 Jumper Placement
J13, J14, and J18 on the board must have jumpers installed on them.
J32 must have a jumper installed on pins 2 and 3.
J28 jumper positions will apply to future capabilities, but are not cur-
rently usable on the NIC.
Your card was shipped with the jumpers properly installed.
Figure 8 Jumper positions
J32
J18
J13
J28
J14