User manual

Nform Monitoring—Navigation Tree
46
12.2.3 HTML configure tab (selected devices only)
The HTML configure tab allows you to change some configuration settings in the device’s SNMP
card. This tab appears only for certain devices with Web-enabled SNMP cards.
To use the HTML configure tab:
• Log on as either Administrator or Power User.
• Click on Nform’s Navigate tab.
• In the left side of the window, click on the device you wish to view.
• In the right pane, click on the HTML configure tab.
• A window asks for the user name and password. Enter the user name and password for the SNMP
card and click OK.
• In the center of the window, click on a configuration function—for example, Web. The example
below shows the Refresh Interval for an HTML-supported device.
• For each configuration function, a window at right displays information that can be changed on
the SNMP card. Click on the Edit button to make changes.
• Enter the information you wish to change and click on the Save button to save the changes
(or click on the Reset button to exit without saving).
• All changes require re-initializing the SNMP card before the changes will take effect. To do this,
click on the Reinitialize button .
NOTE
The Configure feature may not be available on every HTML-supported device.
Click on Edit to make
changes
Save and Reset buttons
appear when needed
Highlight device name,
then click on configuration
category—for example,
“Web”