Datasheet

Multilink Licenses

Multilink License Kits enable enhancements and additional features to be added to the stan-

dard Multilink Installation. Purchasing the Multilink Network Shutdown License allows you to

efficently manage power protection on a UPS by running Multilink on one computer and using

that computer to notify other computers throughout the network of UPS conditions. Purchasing

the Multilink Network Administration License allows Multilink 3.0 to monitor multiple UPSs and

remotely configure and monitor other installations of Multilink 3.0 throughout the network.

AS 400 Card - Interface Kit for Relay Contacts

Optional interface card for communicating to devices such as PLCs (Programmable Logic

Controllers) that require a true relay contact interface rather than opto couplers. In addition

to “on-battery” and “low-battery” signals, the card also provides an “on-bypass”,“on-UPS”,

and “summary alarm” signal, if installed in a UPS with an internal bypass feature. The

Intellislot™ Interface Kit includes the Intellislot

Interface card and the user’s manual. The

RELAYCARD-INT will work with the PowerSure Interactive, UPStation GXT, UPStation

GXT 2U, GXT 6 & 10 and Nfinity.

SiteNet MultiPort 4

The SiteNet MultiPort 4 provides UPS communications to four additional computer

systems attached to a single UPS. With basic signaling for recognizing On-Battery and

Low-Battery conditions, the SiteNet MultiPort 4 delivers orderly shutdown to connected

computers running Liebert's MultiLink

. The RS-232 port remains active with the SiteNet

MultiPort 4 installed allowing more sophisticated monitoring with Liebert's MultiLink

3.0

software. The SiteNet MultiPort 4 supports UPSs equipped with a Liebert Intellislot

port:

PowerSure Interactive, UPStation GXT, UPStation GXT 2U and Nfinity - plus it's user-

installable and hot installable. The SiteNet MultiPort 4 ships with the Intellislot

size com-

munications board, a one-foot four-port cable (one DB25 to four DB9s).

MultiPort 8

The MultiPort 8 Interface Unit provides eight DB9 ports to monitor dry-contact signals (on-

battery, low-battery) for computers running MultiLink

. One of the eight ports also has the

ability to transmit serial data, which allows UPS instrumentation to be displayed on a com-

puter running MultiLink

3.0 software. MultiPort 8 units can be daisy-chained together to

accommodate more than eight computer systems. In a daisy-chained configuration, only

the first MultiPort 8 can provide serial data for instrumentation to a computer system using

MultiLink

3.0 Software.