Specifications

STARTUP and OPERATION
Rosemount Analytical µCEM Continuous Analyzer Transmitter 4-2
1. Plug the external COM cable into J3 circular connector on the bottom of the
uCEM.
2. Plug pocket pc RS232 plug into the J1 on the external COM cable.
3. Plug power supply cable into 5V plug on the COM cable.
4. Turn Pocket PC on.
5. In order to assure no other windows are open press the reset button. Reset
button is located on the back of the pocket PC.
6. Go to tools menu (Icon in upper left hand corner) and click on µCEMTS.
7. Unit will display data in 3 to 5 seconds. If unit does not show data in 3 to 5
seconds repeat procedure starting with number 5.
Note: The Pocket PC can by used on any MicroCEM TS analysis enclosure regardless
of the MicroCEM units IP address.
4.2.2 µCEM Main Window
The µCEM Main Window shown in Figure 4-1 provides the status of the three emissions
channels. The status includes the current reading (updated approximately every 2
seconds), the last 1-minute average, and the last 15-minute average. The status column
(Sts) indicates the status of the measurement and can be any of the values in the Table
4-1.