Installation Manual

ManualsBrandsEmerson ManualsDC PowerEmerson LMS 1000

NetSure™ LMS Data Processing Unit

Installation Instructions, Section 5879 (Issue BA, April 7, 2014)

Spec. No: 58650500, 586505500 Code: Section 5879

Model No: LMS1000 Issue BA, April 7, 2014

[41 of 149]

EIGHT INPUT TEMPERATURE CIRCUIT CARD P/N 506333

CONNECTIONS

Connections to a temperature circuit card are made to terminal

block TB1 located at the edge of the circuit card. Refer to "Making

Connections to an LMS1000 Input/Output (I/O) Circuit Card" in this

section for terminal block TB1 connection information. Refer to

Figure 18 for terminal block pinouts.

Temperature probes connect to TB1 with a white (yellow) and

violet (black) lead pair. Connect the white (yellow) lead to the odd

numbered terminals and the violet (black) lead to the even

numbered terminals.

Note:

Temperature probe lead colors are violet and white. This

probe requires Temperature Circuit Card 506333 firmware

version 1.1.0, or later. Previous version probe leads were black

and yellow. Previous version probes are compatible with

Temperature Circuit Card 506333 firmware version 1.0.1, or

later.

Note:

A firmware upgrade to Temperature Circuit Card 506333 is

required when using the newer version probes with circuit

cards that have firmware versions earlier than 1.1.0.

LMS1000 Temperature Probe Wire Specifications:

• Preferred wire is P/N 1562077, 18 Ga. solid twisted pair,

maximum length is 200 feet.

•

Optional wire is P/N 1562001, 20 Ga. shielded twisted

pair (shield grounded at one end), maximum length is

100 feet.

Procedure:

1. 586505000/586505500: To access terminal block TB1

located on a temperature circuit card, rotate the two

captive fasteners on the front of the cabinet until the

arrow on the fastener points up or down, and pivot the

door open.

582140000/582140001/582126100: Open the bay's

front door.

2. Connect the leads as shown in Figure 18. Ensure that the

green wire from the circuit card is attached to cabinet

ground as detailed in Figure 3.

586505000/586505500: If no more connections are to

be made inside the cabinet, close the cabinet door and

secure with the two captive fasteners (arrow on fastener

points towards outside of cabinet).

582140000/582140001/582126100: If no more

connections are to be made inside the bay, close the

bay's front door.

Figure 18. Connection to an Eight Input Temperature Circuit Card, P/N

506333

Interconnecting the Optional 586505000/586505500

Expansion Assembly(s) (if furnished) to Customer Equipment

The Expansion Assembly(s) is provided with D-type connectors to

interface with customer equipment. Refer to Figure 19 for

connector locations and Table 8 and Table 9 for connector pinouts.

Recommended wire size for monitoring leads is 22 gauge.

Recommended wire size for power leads is 22 gauge. The

ungrounded input power lead should be fused at 0.5 amperes.

The mating half for the D-type connectors is as specified in

SAG586505000/SAG586505500 (System Application Guide).

Note:

Common mode voltage between inputs must not exceed –

0.15 to +0.95 volts.

Note:

Analog input designations A1 through A8 as shown are for

the circuit card only. The actual analog channel number

depends upon the quantity of analog and temperature

circuit cards installed and location of this temperature circuit

card in the system network.

Temperature input

wiring connection

terminals

GREEN WIRE TO CABINET GROUND

TB1

506333