Installation Manual
NetSure™ LMS Data Processing Unit
Installation Instructions, Section 5879 (Issue BA, April 7, 2014)
Spec. No: 58650500, 586505500 Code: Section 5879
Model No: LMS1000 Issue BA, April 7, 2014
[30 of 149]
3. Terminate the cable using appropriate crimp tool, AMP
P/N 2-231652-1 with die set AMP P/N 853400-1.
Attaching 9-Pin Male D-Type Plug
1. Trim and strip (0.75 inch) jacketed cable using
appropriate, commercially available tools.
2. Attach the crimp type contacts to the wires of the cable
using a crimp tool, AMP P/N 90302-1, or 90312-1, or
404494-7. (Strip the wires approximately one quarter of
an inch.) If using the recommended cable, follow the
color scheme shown in Table 2-6.
3. Insert the crimp type contacts (with wires attached) into
the plug housing using an insertion/extraction tool, AMP
P/N 91067-2. A single ended insertion tool is also
available, AMP P/N 91234-1.
4. Assemble the retaining clips onto the receptacle flanges
with the threaded hole facing toward the wire side of the
connector.
Attaching Cable Clamp Assembly
1. A carrier strip with strain-relief gates is packaged with
each assembly. Remove the curved gate and large blank
gate from the carrier strip.
2. Insert the curved gate into the cable clamp slot as shown
in Figure 10. Insert the large blank gate into the unused
slot.
3. Insert the plug into the clamp with the longer row of
contacts in the bottom (portion of cable clamp which is
slotted for cable). Position the cable in the strain relief
channel.
4. Position the cable over the curved gate and close the
cable clamp.
5. Thread the screws into the holes in the cable clamp and
tighten them to complete the assembly.
Table 6. VPS/NPS Interface Cable Wiring
Recommended
Wire Color
From RJ-45 Jack
Located on VPS/NPS
Pin Number
To 9-Pin D-Type Jack
Located on LMS1000
Pin Number
white/blue stripe
1
3
blue 2 2
white/orange stripe
3 -
orange
4
-
white/green stripe 5 -
green
6
-
white/brown stripe
7
-
brown 8 5
Figure 9. RJ-45 Plug
Figure 10. Assembling Cable Clamp Assembly
1 8
Rear View Isometric View
UNUSED SLOT
CABLE CLAMP SLOT
LARGE BLANK GATE
CURVED GATE
PLUG
CABLE CLAMP ASSEMBLY
Note: Cable clamp assembly
may be used for 90° mounting
by exchanging BLANK GATE
and CURVE GATE.