Installation Manual

NetSure™ LMS Data Processing Unit
Installation Instructions, Section 5879 (Issue BA, April 7, 2014)
Spec. No: 58650500, 586505500 Code: Section 5879
Model No: LMS1000 Issue BA, April 7, 2014
[12 of 149]
Figure 3. Installing the I/O Circuit Cards (cont'd from previous page)
Seven-Slot Card Cage
for MCA Customer Alarm
Relay Circuit Cards and/or LMS
Input/Output (I/O) Circuit Cards
Temperature
Circuit Card
Grounding Stud
Locations*
* Note:
Two grounding studs are provided. Each
grounding stud contains two nuts. If a
Temperature circuit card is installed, attach
the Green Wire from the circuit card to one
of the grounding studs, below the bottom nut.
Tighten the top nut down to lock the bottom nut.
LMS Input/Output
(I/O) Circuit Card
4-Input Analog, P/N 506336
8-Input Analog, P/N 514528
12-Input Analog, P/N 520838
8-Input Temperature, P/N 506333
4-Input Binary, P/N 506332
8-Input Binary, P/N 506334
4-Output Relay, P/N 506335
Install LMS I/O Circuit Cards from Left to Right
with Component Side of Circuit Card Facing
the Left as Viewed from the Front.
DO NOT SKIP SLOTS.
582140001
Primary and
Secondary Bays
ECH 1 ECH 2 ECH 3
L
M
S
F1
D
S
M
F2
M
C
A
F3
3A 3A 3A
FA
POWER
CAN BUS* ETHERNET
* RS-485 * TEMP
* Main
Bay
Only
582126100
Primary and
Secondary Bays
Front door assembly removed
in illustrations for clarity.
MONITORING AND
CONTROL SECTION
Seven-Slot Card Cage
for MCA Customer Alarm
Relay Circuit Cards and/or LMS
Input/Output (I/O) Circuit Cards
Temperature
Circuit Card
Grounding Stud
Locations*