Installation Manual

NetSure™ LMS Data Processing Unit
Installation Instructions, Section 5879 (Issue BA, April 7, 2014)
Spec. No: 58650500, 586505500 Code: Section 5879
Model No: LMS1000 Issue BA, April 7, 2014
[142 of 149]
SET USERS
Note:
If "Y" was entered above, the
system responds with...
Persistent Alarm Report
Period:
Type the number of minutes (as referenced from midnight each day)
that the system will wait before contacting the user with another
persistent "User Report" (0-1440 minutes), then press
ENTER
. As an
example, if a time period of 90 minutes is specified, the system reports
at Midnight, 1:30 am, 3:00 am, etc.
Note:
If "Modem" or "E-mail" was entered
above as the Report Device, the
system responds with...
Daily Report (Y or N):
Type
Y
if the user requires a daily "User Report" and
N
if not, then press
ENTER
.
Note:
If "Y" was entered above, the
system responds with...
Daily Report Command:
Type the standard system command or user programmable command
(30 characters maximum) that the system will issue to generate the
daily "User Report", then press
ENTER
.
Note:
If "Y" was entered above, the
system responds with...
Daily Report Time:
Type the desired time that the user wants to be contacted with the
daily "User Report" (format HH:MM), then press
ENTER
.
Note:
If "X25" or "Telnet" is selected as
the REPORT DEVICE and "TL1" is
selected as the REPORT MODE, the
following statement appears if the
user has any channels configured
which do not belong to an Access
Identifier group.
The following channels will be
removed from the user’s
channel configuration because
they are not associated with
an access identifier:
Save changes (Y or N):
Type
Y
if the above entered data is to be saved in the user
configuration and
N
if not, then press
ENTER
.
Note:
If "Y" was entered above, the
system responds with...
Edit User Channels (Y or N):
Type
Y
if it is desired to add or delete specific system channels from the
user configuration and
N
if not, then press
ENTER
. Channels which are
a part of a user configuration are the only channels that the system will
process for the above User Reports or TL1 reports. Users configured to
report via a TL1 network can only specify channels that have been
configured as part of an access identifier.
Note:
If "Y" was entered above, the
system responds with...
Enter channel (e.g. A0012 or
A0001-0006) or D to display.
Add Channel:
Note:
If "X25" or "Telnet" is selected as the
REPORT DEVICE and "TL1" is
selected as the REPORT MODE, the
following statement appears if the
user tries to add a channel(s) which
does not belong to an Access
Identifier group.
Channel not configured
properly for TL1 reporting.
Type
D
to display a complete list of channels in the user configuration.
Type the number(s) of all additional channels to be added to the user
configuration, then press
ENTER
. Channels can be specified by entering
a single channel number (e.g. A0001, B0008), or by entering a range of
channels (e.g. A0001-0008, L0001-0012). To exit, press
ENTER
without
specifying a channel.