Installation Manual

NetSure™ LMS Data Processing Unit
Installation Instructions, Section 5879 (Issue BA, April 7, 2014)
Spec. No: 58650500, 586505500 Code: Section 5879
Model No: LMS1000 Issue BA, April 7, 2014
[136 of 149]
Changing the Relay Channel Configurations
The relay configurations can be changed by using the commands CONFIG. The command CONFIG is also described in "Commands" of the
User Instructions (Section 5847). Section 5847 can be accessed via the CD (Electronic Documentation Package) furnished with your
system. The command, when entered, will display a header that contains the current configuration. Then, individually, the command
will list each item that can be changed, showing the current information, and then prompting for new or revised information to be
entered. If the current information does not need to be changed, press
ENTER to continue.
Command CONFIG: If the command CONFIG is entered, the system will ask that you identify which channel you wish to modify. Another
way of entering the command is to identify the desired channel in the command line by typing the channel number after the characters
CONFIG (ex. CONFIG R1). The various information pertaining to a relay channel that can be changed through this command is described
below. This command is available to users programmed for access to level 6 commands.
Note: Relay channels associated with an energy management channel cannot be programmed.
Note: Parameters which apply only to TL1 commands/messages do not appear for configuration if the TL1 software option is not installed.
CONFIG R_
Command <6>: CONFIG R1
Type
CONFIG R1
, then press
ENTER
.
If this channel’s configuration parameters
are not stored in the nonvolatile database
that contains channel configuration
parameters, the following prompt appears.
Channel R0001 does not exist!
Create Channel? (Y or N):
Type
Y
to continue configuring this channel’s parameters.
Typing
N
terminates the command.
Channel active (Y or N):
Note:
If "Y" is entered, the system will
allow the default configuration
information of the current relay
channel to be changed as shown
below.
Type
Y
if the channel is required to be active and
N
if not, then press
ENTER
.
If "N" was entered above, the system
responds with...
Set channel configuration to
default values? (Y or N):
If
Y
is entered and the user elects to save the changes when prompted,
the channel’s configuration will be removed from the nonvolatile
database that contains channel configuration parameters.
If
N
is entered, the channel’s configuration will remain in the
nonvolatile database that contains channel configuration parameters.
Name:
Type the desired name for this relay channel (30 characters maximum),
then press
ENTER
.
Sub-access Identifier:
This parameter applies only to TL1 commands/messages. Type the
name (20 characters maximum) of the sub-access identifier that this
channel belongs to, then press
ENTER
. The group of LMS1000 channels
monitoring a sub-entity in an NMA system should have the same
access identifier and sub-access identifier. Only alpha-numeric
characters can be entered for this parameter. TL1 uses specific values
for this parameter. Refer to TA-NWT-001360, Table 4-1.
Alarm Type (Y or N):
Type
Y
if the alarm condition determined by this channel is required to
be recorded in the alarm log (required if System Alarm Reporting is
desired for this channel, and/or an alarm class of 1 through 8 is
assigned to this channel) when it is activated and
N
if not, then press
ENTER
.