Installation Manual

NetSure™ LMS Data Processing Unit
Installation Instructions, Section 5879 (Issue BA, April 7, 2014)
Spec. No: 58650500, 586505500 Code: Section 5879
Model No: LMS1000 Issue BA, April 7, 2014
[116 of 149]
Module 4 List Number: BK
5. After all configuration parameters are presented, the
system prompts to save the changes. Type
Y and press
ENTER to save the Node's configuration.
Save changes (Y or N): Y
Storing node configuration
6. The system prompts to add channels to the Node's
configuration. Type
Y then press ENTER .
Edit Node Channels (Y or N): Y
7. Add from the available channels those that are active in
the system.
Note: Type the number(s) of available channels to be
added to the Node's configuration, then press
ENTER. Channels can be specified by entering a
single channel number (e.g. A1, B8), or by entering a
range of channels (e.g. A1-8, B1-12). To continue,
press
ENTER without specifying a channel.
Enter channel (e.g. A12 or A1-6) or D to
display.
Add Channel: A1
Add Channel: A7-11
Add Channel: B1-4
Add Channel:
8. The system prompts to delete channels that were
previously added to the Node's configuration. To
continue, press
ENTER without specifying a channel.
Enter channel (e.g. A12 or A1-6) or D to
display.
Del Channel:
Del Channel:
9. The system prompts to configure another Node. Type
Y
then press
ENTER if there are remaining Nodes that need
to be configured. Otherwise type
N then press ENTER .
Repeat the above steps until all Nodes are configured.
Configure another node? (Y or N):
10. If you exit the NODE ADD command without configuring
all Nodes, use the NODE CONFIGURE command.
Hint: Use the NODE LIST [node_number] command or
NODE LIST LONG command to view additional
information on the Node to be configured.