Application Guide

SAG586505000 System Application Guide
SAG586505500 Spec. No. 586505000 (Model LMS1000)
Issue AZ, April 7, 2014 Spec. No. 586505500 (Model LMS1000)
Page 36 of 62
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
• Set NPS Temperature Readings to Celsius
• Set NPS Temperature Readings to Fahrenheit
• Set NPS Temperature Compensation Slope Setting
• Set NPS Temperature Compensation Maximum Voltage Setting
• Set NPS Temperature Compensation Minimum Voltage Setting
• Reset NPS Inventory to Reflect Current System Configuration
• Set the following parameters for NPS MCA CAN I/O circuit cards
• Designate Analog Input as "Auxiliary" or "Distribution"
• Set the Scale Factor for Analog Input and Output
• Designate the Alarm State for Binary Inputs
• Set Custom Text Messages (Names)
• Enable or disable NPS System Alternate Current Limit operation
• Set NPS System Alternate Current Limit Capacity setting
• Set NPS System Sequencing Delay setting
Available to LMS1000 Users with Access to Level 6 Commands via the
DOWNLOAD NPS, DOWNLOAD TFTP NPS, UPLOAD NPS,
and UPLOAD TFTP NPS Commands, respectively
• Download the Configuration of the NPS to an ASCII File
• Upload a Previously Downloaded Configuration to the NPS
1.4.21 IP Parameters
(A) The system "IP" address can be set.
(B) The "Gateway Address" can be set and listed.
(C) The "Netmask Address" can be set and listed.
1.4.22 WEB Interface
• Allows you to access the LMS1000 over the Internet via a WEB Browser.
• Displays LMS status, statistics, logs, and inventory in WEB pages.
• Displays User configurable status pages and channel groups in WEB pages.
• Edit pages for basic LMS settings, channel configuration, and control programs.
• Requires Google Chrome (version 24.0.1312.57 or later), Firefox (version 18.0.2 or later),
or Microsoft Internet Explorer (version 7.0 or later).
• Requires LMS1000 with firmware version 11.0.0.0, or later.
1.4.23 SNMP: LMS1000 supports SNMP (Simple Network Management Protocol) interface in a
TCP/IP network. Communications to and from LMS1000 is accomplished via a MIB
(Management Information Base) browser. An Ethernet port is provided for this network
connection.
(A) SNMP Alarm Reporting via the Ethernet Port: All system alarms are reported via the
SNMP interface. Alarms sent via SNMP traps can be configured for three different types.
These are …
(1) TRAPS OCCURRED, selects reporting of new system alarms that have occurred.
(2) TRAPS RETIRED, selects reporting of system alarms that have cleared.
(3) TRAPS PERSISTENT, selects periodic reporting of system alarms that still exist. The
Persistent Alarm Period specifies how frequently the system will attempt a Persistent
Alarm Report.
(B) SNMP Parameters:
(1) The "Get" community string can be set and listed.
Home