Application Guide

System Application Guide SAG586505000
Spec. No. 586505000 (Model LMS1000) SAG586505500
Spec. No. 586505500 (Model LMS1000) Issue AZ, April 7, 2014
Page 33 of 62
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Digital Temperature Compensation Minimum Voltage
Battery Current Limit
Relay Test Time
Test/Equalize Timeout
Low Voltage Disconnect "Disconnect" (for each installed LVD)
Low Voltage Disconnect "Reconnect" (for all installed LVDs)
Temperature Probes Alarms
• View VPS/NPS Equipment Inventory...
PCUs
System Shunts
Subsystem Shunts
Battery Shunts
LVDs
Temperature Probes
Vacant PCU Mounting Positions
Maximum System Current Capacity
System Operating Mode (Float or Equalize [forced, manual, timed, auto])
Temperature Compensation Mode (None, Analog, Digital [Highest, Averaged, Probe #1])
MCA Customer Text Message (custom name), Spec. No., Serial No., Software Version
Each PCU Customer Text Message (custom name), Spec. No., Serial No.,
Output Voltage Rating, Current Rating
Available to Indicated LMS1000 Users via the SET NETSURE Commands
LMS1000 Users with Access to Level 4 Commands
• Set VPS/NPS NAG Minutes (Audible Alarm Cutoff Reset Time Period)
LMS1000 Users with Access to Level 5 Commands
• Set VPS/NPS System High Voltage Alarm #1 Setting
• Set VPS/NPS System High Voltage Alarm #2 Setting
• Set VPS/NPS System Battery On Discharge Alarm Setting
• Set VPS/NPS System 50% Battery On Discharge Alarm (Voltage is Very Low Alarm)
Setting
• Set VPS/NPS System Overcurrent Alarm Setting
• Set VPS/NPS Subsystem High Voltage Alarm Setting (if installed)
• Set VPS/NPS Subsystem Low Voltage Alarm Setting (if installed)
• Set VPS/NPS Subsystem Overcurrent Alarm Setting (if installed)
• Set VPS/NPS Relay Test Time
• Set VPS/NPS Temperature Probe Alarms
• Set VPS/NPS Auto Equalize Multiplier
LMS1000 Users with Access to Level 6 Commands
• Set VPS/NPS MCA Remote Access Password
• Set VPS/NPS System Operating Mode (Float or Test/Equalize)
• Set VPS/NPS System Output Voltage Calibration Reading
• Set VPS/NPS Subsystem Output Voltage Calibration Reading (if installed)
• Reset VPS/NPS System Output Voltage Calibration Reading to Factory Default
• Reset VPS/NPS Subsystem Output Voltage Calibration Reading to Factory Default (if
installed))
• Set VPS/NPS Analog Battery Charge Temperature Compensation Module's Calibration
Voltage
Home