User manual

Installation
11 Liebert
®
Liqui-tect
®
2.3.1 Mounting the Panel
NOTICE
Risk of improper installation. Can cause property damage.
Check building plans and other relevant documents to determine whether mounting the
Liebert Liqui-tect panel at the selected location might cause cutting or otherwise damaging
electrical or communication wiring or pipes.
1. Mark the wall for the cutout to accommodate the panel, using the back of the unit as a template.
2. Drill a pilot hole for the saw blade, if required.
3. Use the saw to cut out the marked section of the wall (if not new construction).
4. Rest the Liebert Liqui-tect panel in the wall and mark where mounting screws will be inserted
into the wall studs or other support member.
5. Remove the panel and drill the holes for the mounting screws or wall anchors. Clean up the
debris.
6. Reverse the slide direction of the rectangular access doors on the top and bottom of the Liebert
Liqui-tect panel. Leaving the access doors as shipped from the factory prevents them from being
opened when the panel is flush mounted in a wall.
7. Attach any field-supplied mounting hardware.
8. Reinsert the assembly into the wall.
9. Insert and tighten the screws or wall anchors.