User manual

ManualsBrandsEmerson ManualsHome Safety ProductLiqui-tect MC68HC16Z1

Installation

Liebert

Liqui-tect

Figure 4 Mounting dimensions

2.3 Flush-Mounting the Liebert Liqui-tect Panel

The Liebert Liqui-tect panel may be flush mounted according to company practices—either with

screws through the sides of the panel into wall supports or with hanging hardware that attaches to

the back of the panel. After determining how and where to place the unit, check to ensure that you

have all the hardware required to install the panel in the wall. Obtain the needed tools.

Required tools

•Saw

• Electric drill

• Screwdriver

• Marker to denote layout of the hole to accommodate the Liebert Liqui-tect panel

• Trim ring and associated hardware

• Mounting hardware

NOTE

Removing the conduit knockouts before mounting the Liebert Liqui-tect panel on the wall will

ease installation and prevent strain on the mounting hardware and wall. It is imperative to

remove the knockouts if the unit is to be flush-mounted.

The rectangular access doors on the top and bottom of the Liebert Liqui-tect panel must be

removed from the outside of the panel and reinstalled on the inside of the panel. Leaving the

doors as shipped from the factory prevents them from being opened when the panel is flush

mounted in a wall.

SMALL ENCLOSURE

0.213"

(5.4mm)

Mounting Slot

0.375"

(9.6mm)

Liebert Liqui-tect panel

back plate

12.5"

(317.5mm)

0.213" (5.4mm)

Bottom hole diameter

10"

(254mm)

LARGE ENCLOSURE