User manual

Installation
9Liebert
®
Liqui-tect
®
2.2 Surface-Mounting the Liebert Liqui-tect Panel
After determining where to place the unit, check to ensure that you have all the hardware required to
install the panel on the surface of a wall. Obtain the needed tools and material.
Required tools
• Electric drill (if surface is too hard to drive screws without pilot holes)
• Screwdriver
• Marker to denote layout of holes
• Four screws, each #10
2.2.1 Mounting the Panel
NOTICE
Risk of improper installation. Can cause property damage.
Check building plans and other relevant documents to determine whether mounting the
Liebert Liqui-tect panel at the selected location might cause cutting or otherwise damaging
electrical or communication wiring or pipes.
1. Mark the wall for mounting holes, using the back of the unit as a template (see Figure 4).
2. Drill holes, if required, to install the four #10 screws that will secure the Liebert Liqui-tect panel
to the wall. Clean up the debris.
3. If the wall material is not strong enough to hold the screws securely, use wall anchors.
4. Install the top two screws—the screw heads must be small enough to slip through the larger,
bottom portion of the pear-shaped mounting slot in the Liebert Liqui-tect panel (see inset in
illustration at right). The screws must also be large enough to extend over the edges of the top of
the mounting slot.
5. Hang the Liebert Liqui-tect panel on the screws, letting the panel slip down until the screws are
in the smaller, upper portion of the slot.
6. Tighten the screws until they are snug.
7. Insert the remaining two screws in the bottom holes on the back of the panel and tighten.
NOTE
Removing the conduit knockouts before mounting the Liebert Liqui-tect panel on the wall will
ease installation and prevent strain on the mounting hardware and wall. It is imperative to
remove the knockouts if the unit is to be flush-mounted.