User manual

Introduction
Liebert
®
Liqui-tect
®
6
S-Power receptacle
(Transformer Module)
115VAC power receptacle to power laptop during
configuration and diagnostics. Receptacle not
available on 230VAC Transformer Module.
2.4.2: Input and Output Power Connections -
Large Enclosure
3.0: Connections and Configuration
T-Power On/Off
switch (Transformer
Module)
Power switch to turn power On/Off to both
Transformer Module 24VAC connectors and power
receptacle.
2.4.2: Input and Output Power Connections -
Large Enclosure
3.0: Connections and Configuration
U-24VAC connector
(Transformer Module)
One of the two 24VAC connectors for power (the
second is also on the right side of the Transformer
Module near the top). Each connector is rated for
40VA.
2.4.2: Input and Output Power Connections -
Large Enclosure
3.0: Connections and Configuration
V-LCD connector Connection for the LCD located on the front door. N/A
W-LCD contrast
adjustment
Adjustment contrast for the LCD located on the front
door.
N/A
X-Reset switch
Reset switch to reset the panel. Same as re-
powering the panel.
N/A
Y-24VAC power
connector
Power connection for the controller. Requires
24VAC.
2.4: Connect Power to the Liebert Liqui-
tect Panel
Z-Transformer
Module
Transformer Module used to convert 115VAC or
230VAC to 24VAC. Available only in the large
enclosure.
2.4.2: Input and Output Power Connections -
Large Enclosure
Table 1 Controller board components (continued)
Item Description More Information