Operating instructions

96 STS2 Touch Screen Display
Figure 49 History Log
To use the History Log:
1. Select LOGS from the menu bar to open the Logs menu.
2. Select either HISTORY LOG 1 or HISTORY LOG 2 from the menu.
3. Select the appropriate buttons to replay the log:
• Select PREV to go to the previous frame in the sequence.
• Select NEXT to go to the next frame in the sequence.
• Move the green cursor to the location from which you would like to play the sequence of
events.
• Select REPLAY to play the frames automatically from the point of the cursor.
• Select STOP to halt the replay.
• Select RESET to return to the first frame in the log.
4. Select EXIT to close the History Log. The data remains in the log.
• Use CLEAR HLOGS to remove the data from both history logs.
13.6.3 Source Transfers
The Source Transfer choice (SOURCE XFERS) allows you to manually select a preferred source.
To switch the primary source, refer to the instructions in Manual Transfer / Preferred Source
Selection on page 59.
13.6.4 Startup Procedure
You can access instructions for starting the STS2 from the menu bar.
• From the menu bar, select STARTUP PROC.
These instructions are also provided on 10.1 - Normal System Turn-On on page 58 for Color
Graphical display units and 14.2.1 - Normal System Turn-On on page 103 for LED Display
units.
13.6.5 Bypass Procedure
You can access instructions for bypassing the static transfer switch from the menu bar.
• From the menu bar, select BYP. PROC.
The instructions are provided in the display panel.
Bypass procedures are also discussed in 10.4 - Maintenance Bypass on page 61 for Color Graphi-
cal display units and 14.2.3 - Maintenance Bypass on page 104 for LED Display units.
NOTE
Event and History Logs are protected by security. The password or a
disabled key lockout is required on such equipped units to clear these logs.