Technical Specifications

BACnet Communications - Thermal Management Products
Liebert
®
IntelliSlot
®
Modbus/BACnet 328
Supply Refrig Temp Sensor Issue - Event
Type
The event type for the [Supply Refrigerant Temp Sensor Issue] event.
Supply Refrig Under Temp Control - Event
Enable/disable the activation of the [Supply Refrigerant Under Temp] event. If
set to “disabled,” the event will not be annunciated. This implies that the event
will not be placed in any active event list or in any event history list.
Supply Refrig Under Temp - Event Type The event type for the [Supply Refrigerant Under Temp] event.
Supply Refrigerant Over Temp
Event that is activated when [Supply Refrigerant Temperature] exceeds
[Supply Refrig Over Temp Threshold]. The event is deactivated when the
temperature drops below the threshold.
Supply Refrigerant Temp Sensor Issue
The supply refrigeramt temperature sensor is disconnected or the signal is out
of range.
Supply Refrigerant Temperature Supply refrigerant temperature.
Supply Refrigerant Under Temp [Supply Refrigerant Temperature] has dropped below a specified threshold.
System Condensation Detected - Event
Control
Enable/disable the activation of the [System Condensation Detected] event. If
set to “disabled,” the event will not be annunciated. This implies that the event
will not be placed in any active event list or in any event history list.
System Condensation Detected - Event
Type
The event type for the [System Condensation Detected] event.
System Condensation Detected System condensation detected.
System Control Mode System control mode.
System Date and Time The system date and time
System Event Acknowledge/Reset Reset and/or acknowledge all events.
System On/Off Control Turn system functionality on or off.
System Operating State Reason The reason the system is in the current operating state.
System Operating State Current operating state of the system.
System Status The operating status for the system.
Unit Code Missing Unit code has not been entered and saved.
Unit Communication Lost Master has lost communication with one or more networked units.
Unit Off Unit was turned off.
Unit On Unit was turned on.
Unit Partial Shutdown
An event has occurred requiring some system components to be shutdown
and disabled.
Unit Shutdown
An event has occurred requiring the unit to be shutdown and disabled to
prevent damage to the system.
Unit Standby Unit was placed in standby mode.
Visual ID Control
Visual identification control to display an LED flashing sequence, allowing it to
be visually located.
Water Under Floor - Event Control
Enable/disable the activation of the [Water Under Floor] event. If set to
“disabled,” the event will not be annunciated. This implies that the event will
not be placed in any active event list or in any event history list.
Water Under Floor - Event Type The event type for the [Water Under Floor] event.
Water Under Floor Water under the floor is detected.
Table 99 Liebert XDP
™
, Liebert XDC
™
- Glossary (continued)
Data Label Data Description