User's Manual

Installation
3
6. Select either interface Option 1 or 2 below (also see
Step 7 and 3.0 - Pin Configuration).
Option 1: Hardwire (terminal block pins) - Use these
guidelines for terminal block specifications:
Option 2: DB25 pins
a. Disconnect the Hardwire
Adapter board by removing
the two mounting screws,
as shown at right.
b. Pull the Hardwire Adapter
board away from the Relay
Card.
7. Configure the terminal block or DB25 pins, depending on
which interface option you chose in Step 6 (see figure
below and Table 1 in 3.0 - Pin Configuration).
Acceptable
Wire Size
Wire Strip
Length
Recommended
Tightening Torque Screw
30-16 AWG
0.24-0.28 in.
(6-7mm)
1.73 lb-in
(2 kgf-cm)
M2
Remove
screws
Hardwire
Adapter
board
DB25 PINS
(Option 2)
13
1
25
14
Pin
numbering
TERMINAL BLOCK PINS
(Option 1)
1
11
24
14
Pin
numbering
See Table 1 for configuration of terminal block & DB25 pins.
Hardwire Adapter
board
Intellislot
card