User manual

Service Menu Parameters
Liebert
®
iCOM
®
for Liebert DSE
™
126
S317 Compressor 1 Capacity—Standard compressor models. Selects the capacity the compressor
should run at. The range is 20 to 100%.
S317 Compressor 1A Capacity—Tandem compressor models. Selects the capacity the compressor
should run at. The range is 20 to 100%.
S318 Compressor 1 Cycle Ramp—Standard compressor models. Enables Compressor 1 Cycle
Ramp.
S318 Compressor 1A Cycle Ramp—Tandem compressor models. Enables Compressor 1A Cycle
Ramp.
S319 Compressor 1 LLSV—Shows the status of the liquid line solenoid valve for Compressor 1.
S320 Compressor 2 Mode—Read-only status when Manual mode is not enabled. If Manual mode is
enabled, this parameter selects the mode of compressor operation. The choices are Run, Evacuate and
Charge. To access any mode, press the Enter key while S320 is highlighted. The compressor mode
may be changed by pressing the Up or Down arrow key. Once the desired mode is shown, press the
Enter key. The compressor state on the following line must be placed to On if Run or Charge mode
has been selected. No further action is required for Evacuate mode.
S321 Compressor 2—Standard compressor models. Read-only status when Manual mode is not
enabled. When Manual mode is enabled, the parameter can be change from No to Yes, allowing the
compressor to operate as defined on the previous line.
S321 Compressor 2B / 2A—Tandem compressor models. Read-only status when Manual mode is not
enabled. When Manual mode is enabled, the parameter can be change from No to Yes, allowing the
compressor to operate as defined on the previous line.
S322 Compressor 2 Capacity—Standard compressor models. Selects the capacity the compressor
should run at. The range is 20 to 100%.
S322 Compressor 2A Capacity—Tandem compressor models. Selects the capacity the compressor
should run at. The range is 20 to 100%
S32A Compressor 2 Cycle Ramp—Standard compressor models. Selects the capacity the
compressor should run at. The range is 20 to 100%.
S32A Compressor 2A Cycle Ramp—Tandem compressor models. Selects the capacity the
compressor should run at. The range is 20 to 100%.
S32B Compressor 2 LLSV—Shows the status of the liquid line solenoid valve for Compressor 2.