Unit installation

Liebert iCOM Control
23
Figure 22 Rack setup screen, page 3 of 3
Once a sensor has been assigned to either control or display its temperature data, a custom label can
be assigned to the sensor. This step is not required for the sensor to operate but does provide a logical
name for identification. Navigate using the arrow and enter keys to highlight the Assign Names num-
ber range. Once the range is selected then press the Enter key to move to the rack location blocks at
the bottom of the screen. The Up and Down arrow keys can be used to select any alpha or numeric
value up to four positions.
Figure 23 Rack overview screen
If the Rack Setup menus are configured in the Service menu to locate and label the remote rack sen-
sors, then the Rack View in the User menu should look similar to the screen above. This screen will
show the node number at the top of each block, the label and the actual temperature that each sensor
is currently measuring.