Unit installation

Prepare the Liebert CRV for Installation
11
4.0 PREPARE THE LIEBERT CRV FOR INSTALLATION
1. Using a screwdriver, open the electrical panel and the lower front baffle panel to prepare for
installation.
2. Open the rear panel, referring to Figure 9. The documents are in the lower rear compartment.
Figure 9 Document shipping location
3. After the Liebert CRV is in its final installation position, adjust the four base supports, or feet,
with an adjustable wrench. Ensure that the unit is level to avoid corrosion or health hazards
caused by condensate accumulation.
a. Turning the base supports, or feet, clockwise, will extend them, lifting the unit one corner at a
time.
b. Tighten the nut on the top of each adjustable foot, inside the Liebert CRV, to lock the feet.
Figure 10 Adjust leveling feet
Documents are shipped
in the lower compart-
ment on the rear of the
Liebert CRV
Adjust the
height of the
feet
Tighten this nut after
the foot is adjusted to
the desired height