Unit installation

Inspection and Unpacking
9
3.4 Removing the Unit from the Pallet Using Piano Jacks
1. Remove the 16 lag bolts that secure the four top
deck boards, two on each end of the pallet. The
lag bolts can be removed using a 1/2" socket
wrench, open-end wrench or pliers.
2. Remove the four deck boards.
3. Open the top panel door with the mounted
control.
4. Remove the bottom baffle panel assembly by
removing the screws using a standard
screwdriver.
5. Set the baffle panel assembly aside in a safe
location until instructed to reattach it.
6. Close and latch the top panel door.
7. Acquire a set of piano jacks rated to properly
handle the unit weight and size.
8. Raise the forks of the piano jacks to contact the
bottom of the unit base.
9. Place the piano jacks against the unit. Place
nonabrasive, protective material between the
piano jacks and the unit panels.
10. Secure the piano jacks to the unit.
11. Use the piano jacks to raise the unit so the
pallet is just off the ground.
12. Use a Phillips screwdriver to remove the 12
wood screws, six from each side of the pallet.
13. Remove the two runner add-on parts.
14. Use the piano jacks to lower the unit so the
pallet rests firmly on the ground.
15. Bolts used to secure the unit to the pallet are
now accessible.
16. Bolts are recessed into the deck boards of the
pallet.
17. Remove the four bolts, two on each side of the
pallet. The bolts can be removed using a 1/2"
socket wrench, open-end wrench or pliers.
18. Remove the three lag bolts from one side of the
remaining pallet deck boards. The lag bolts can
be removed using a 1/2" socket wrench, open-
end wrench or pliers.
19. Remove pallet parts, including wooden spacer
boards, from under the unit.
20. The unit is now supported only by the piano
jacks.
21. Take the wooden spacer boards, removed in
Step 19, and place them on the ground under
the unit base.
22. Using the piano jacks, slowly lower the unit
until the forks of the piano jacks touch the
ground and the unit base rests on the spacer
boards.
23. The unit is ready to have the piano jacks removed.
Steps 1 - 2 Steps 3 - 6
Steps 7 - 10 Steps 11 - 14
Steps 15 - 17 Steps 18 - 19
Steps 20 - 22 Step 23