Manualshelf

User manual

ManualsBrandsEmerson ManualsComputer equipmentLiebert ICOM-DO
81828384858687888990
Service Menu Parameters
83
Figure 72 iCOM-DO Overview and Override - Page 1
Liebert iCOM-DO—This parameter shows the connection status of a Liebert iCOM-DO card. It dis-
plays “connected” when a Liebert iCOM-DO card has been set up and connected to the Liebert iCOM
via the CAN bus.
Override—Selecting Override permits manual testing of the Liebert iCOM-DO by activating each
output on the following screen.
Figure 73 iCOM-DO Events Setup - Page 2
Status—This column shows whether an output is in a normally closed or normally open state.
Output #—This column shows which output is tied to a particular alarm. The default values are set
to be the same output as the Liebert ENV-DO card, the predecessor to the Liebert iCOM-DO.
ID—This column displays the number of the Liebert iCOM-DO. Currently only one Liebert iCOM-DO
card is supported.