User's Manual

Liebert iCOM
®
Control—Firmware Version XP1.00.DCP.01R
57 Liebert
®
DCP
™
Figure 64 System/Network Setup screen—System, page 1 of 2
Number of Connected Units—Shows the number of displays connected. This is always 1.
Configuration Safe—Saves or loads configuration settings for the display that have been modified
from the factory defaults to an internal file that can be downloaded/uploaded using the Liebert
iCOM
®
Service Tool. Selecting Save will write the settings to the internal storage file and selecting
Load will write the settings from the internal storage file to the application software. The internal file
is updated automatically every 12 hours.
Network Safe—Saves or loads network settings for the display that have been modified from the
factory defaults to an internal file that can be downloaded/uploaded using the Liebert iCOM Service
Tool. Selecting Save will write the settings to the internal storage file and selecting Load will write
the settings from the internal storage file to the application software.
SW Version—Contains the application software version loaded onto the Liebert iCOM display.
Figure 65 System/Network Setup screen—System, page 2 of 2
IP Address—Contains the network address of the display. This address must be unique on the
network. The factory default is 192.168.254.003.
SYSTEM/NETWORK SETUP (page 1 of 2) SYSTEM
to confirm
for next/previous unit
then
to select parameter
to change parameter
PASSWORD (Actual Level 0)
Number of Connected Units
Configuration Safe
Network Safe
SW Version
S801
S802
S803
S804
S805
S806
S807
S808
S809
S810
S811
????
1
No
No
OK
OK
XP1.00.010.STD
SYSTEM/NETWORK SETUP (page 2 of 2) SYSTEM
Attention: any changes done on these parameters
must be followed by a 'Save+Reboot ' command .
PASSWORD (Actual Level 0)
IP Address
Netmask
Gateway
MAC
U2U Protocol
U2U Address
U2U Group
Bootloader Variables
S812
S813
S814
S815
S816
S817
S818
S819
S820
S821
S822
????
192.168.254.003
255.255.255.000
0.000.000.000
00:00:68:19:40:C7
GBP
33
1
NoOK