User's Manual

Liebert iCOM
®
Control—Firmware Version XP1.00.DCP.01R
Liebert
®
DCP
™
48
Status Remote Shutdown—Displays the status of the unit’s remote shutdown input.
Status Fan Failure—Displays the status of the dry contact to communicate fan failure at a module.
(The dry contacts are not used to communicate a fan failure alarm when using CANbus.)
Status Diff Press Switch 1—Displays the status of the differential pressure switch.
Status Customer Input 1—Displays the status of the customer input 1 alarm.
Status Condensation Detect—Displays the status of the dry contact to communicate condensate
detection at a module.
Status Unit Ready—Shows unit status when a secondary device, such as a fire detection system, is
employed.
Figure 54 Diagnostics/Service Mode screen, page 6 of 6
Page 6 applies to the Liebert XDC
™
only. No Liebert DCP parameters are present.
DIAGNOSTICS/SERVICE MODE (page 6 of 6) UNIT 01
S356
S357
S358
S359
S360
S361
S362
S363
S364
S365
S366
to confirm
for next/previous unit
then
to select parameter
to change parameter
PASSWORD (Actual Level 0) ????