Manualshelf

User's Manual

ManualsBrandsEmerson ManualsRacks and Integrated SolutionsEmerson Liebert DCP Water-Based Pumping Unit 200kW
11121314151617181920
Installation
11 Liebert
®
DCP
™
2.2.1 Connecting High-Voltage Cables
1. Turn the Liebert DCP’s disconnect switch to the Off position (see Figure 9). Open the front doors
and push down on the enclosure cover latch to open the hazardous voltage enclosure cover.
Figure 9 Front view of Liebert DCP and electrical enclosure
2. Determine which knockouts in the electrical enclosure will be used and remove them (see
Figure 10).
Figure 10 Electrical enclosure knockout location for hazardous voltage wiring
Liebert iCOM
User Interface
Disconnect
Switch
Front of Liebert DCP
Enclosure Cover
Latch
Hazardous Voltage
Enclosure Cover
Hazardous
Voltage
Enclosure Cover
Liebert DCP Input
Power Knockout
Enclosure Cover Not Shown