Owner's Manual

TV Speakers
Select the audo output frorn the unit's speakers, o1" not, If your
amplifier s HDbql link function compat ble and connected by
an HDNI cable to this unit, some sound operations such as
volume up can be changed by using this unit's remote control.
Hake sure [fun-Link Control] is set to [On]. ,,_ p.22
Use &/T to select the des red option, then press OK,
On The sound wil be output fl_om the unt's speakers,
Off The sound wil not be output fi-om the unit's
speakers.
You can centre audio output fl-om your
Ext. Amp connected HDNI nk devices by usng this unt's
remote control,
17
Autoprogram
if you switch wires (e,g. between antenna and C/XiV) or f you
move the unit to a d ftSerent area after the nitial setting, or f
you restore the D]V channels you deleted, t s recommended
to use Autoprogram to perform a new channel search .....
1 Use &/T to select [Autoprogram],then press OK. if
2. Use &/_' to select an approprate option, then press OK.
Primary MTS
You can set the output mode as a default for the sound mode
(NISC only).
This sett ngs not nterlocked when you change the output
mode by pressing SAR [Sound Functions] ,,_ p.12
Use &/Y to select the des red option, then press OK,
Stereo Outputs stereo dud o,
Hono Outputs mono aud o,
SAP Outputs second audio program,
Before you begin:
Hake sure the unt is connected to antenna or cable,
1 Use &/Y to select the _temyou want to adjus¢,then press
OK.
• When connected toVHF/UHF antenna, select [Antenna].
• When connected to CATV, select [Cable].
• [Autoprogram] will begin.
i'¸i:
ili!_{
• When the scanning and memorzing are completed, the ;:
lowest memorized channel will be d splayed.
Note
After sctt n£ [Autoprogram], using CH _i,/_r on the _rnote
centre skps unavailabe p1_£_ ms automatically.
If you _e not receiv n£ a sgnal fl_m your cable sol v co, contact
the Cabe prey de_:
If you press (]) or MENU durng autoproglam, the setup of TV
channels w be canceed.
Even if [Autoprogram] s competed, the ch_nne se_in£ w be
oat fthe AC powel cord s unplugged before the unit goes I_to
standby mode by prcss n£ _),
The PIN code will be requ red once you sot a PIN code n the
[Child Lock]. ,,,_ p.20
If you want to change youc PIN code, foow the nstruction of
[Change PIN]. u,_,p.21
2. Adjust the following items.