Owner's Manual

Initial Setup
7his section will guide you through the unit's nitial setting
which ndudes selecting a language for your on screen menu
and autoprogram, which automat tally scans and memor zes
v ewabie channels.
Be[ore you begin:
Make sure the unt is connected to antenna or cable.
1 After makng all the necessary connect ons,
press 6 to turn on the unit.
• It may take a few moments to turn on the unt for the
first time.
• [Initial Setup] menu appears automat tally after the
unt is turned on.
2 Use _t,/T to select the on screen language from the
choices (Engl sh / EspaBol / Franc a s) on the rght sde of the
[V screen, then press OK.
3 Use A,/Y to select [Antenna] forIV channels o1" [Cable]
for CATV channels, then press OK.
• [Autoprogram] will begn.
4
11
Use 4/1_ to select the desired Iocat on setting, then press
OK.
[Home] is ENERGY S Th,Ru_qualified sett ng.
Select [Retail] s_ore,the unit will be set up with
predefined setting for retail d splays. In this setting, the
power consumption may possibly exceed the limited
requirement of the ENERGY S[_R _'_qualification.
Select [Home], the unit is set to maxmze the energy
efl]c ency for home setting and t can be adjusted
through a choice of picture and sound quality accord ng
to 7our pref;arence. Use this setting to remove the
E St cker f vis hie fi'om the displa)4 ma_ p.23
When the ntial setup s completed,the lowest
memorized channel w+th the confirmat on message of
the location setLing will be displayed on theTV screen.
You must set [Home] n step 4. Othe+wise, [Picture]
and [Sound] settings you adjusted will not be
memorized after the unt goes into sq"andby mode.
No_2
If you a_e not _ece,v ng a sgnal fl-om your cable serv ce, contact
the Cabe prov dens
If you press (_ or iViENU durng autoproglam, ths setup of TV
channels w! be canceedL
The init al autoprog_m function can be executed re1 ethel-
[Antenna] or [Cable] ony once.When you change the
connect on [Antenna/Cab e), set [Autoprogram] aganL m_-p.17
If them is no signa input fi-om the at_tenna terminal and no
operat on for several seconds after you turn on the unit, he pful
hints appeal SLFOIow the instruct ons listed on theTV screen.
Z}
}:_!ii
_iiili
After an initial setup is completed...
• If you want to scan the channels automatically again.
[Autoprogram] ma_ p.17
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels] ma_ p.18
° IfTou want to change to another language.
[Language] ma_ p.23
• IfTou want to change the location setting.
[Location] ,m_ p.23