User manual

H990
HC1100 /GN1100
A
B
C
D
6
A
B
C
A
B
A
A A
B B
B
C C
blue tube
DO NOT plug in unit until
water flows from tap
A
B
H990
HC1100 /GN1100
leave 6.4 mm
exposed
Hang tank and
tighten screws
with only
1/2 turn
clockwise.
Turn screws
until snug.
FILTRATION STANDARD ON HC1100 & GN1100
OPTIONAL ON H990
Typical Complete Installation
B
1
small white tube
2
3
400 mm or less
from tap base
and
760 mm or less
from standard
grounded outlet
From water
supply
To tap
See Installation, Care & Use Manual for important cautions, warnings and dangers
DO NOT extend plumbing
or electrical lines
Turn off
cold water
supply
Quick & Easy Steps to Steaming Hot Water
white tube
Press ALL tubes in once again to ensure secure fit.
O-Ring
Wing nut
Rubber gasket
white tube from filter white tube from filter
white tube white tube
A
copper tube
Hex Tool
(included)
Tank
must be
mounted
level.
A
Make sure to use
rubber gasket
to ensure proper seal.
GN1100
HC1100
H990
Property Damage: Make sure bends in all water lines are smooth and
unkinked, with no pinching, twisting or blockage. Pinched or blocked
water lines may cause damage to the dispenser tank.
Electric Shock Hazard:This appliance MUST be earth (grounded). Using an ungrounded appliance can result in
serious injury or death from electric shock. Improper connection of the equipment grounding conductor can
result in the risk of shock by electricity.
To prevent damage or unit operating properly, the water pressure must be between 172 kPa - 862 kPa (1.7 bar - 8.6 bar; 25 psi - 125 psi)
B
copper tube
Quick Connect Fitting John Guest Fitting
®
www.insinkerator.com