Instruction manual

g. Position gland clamping insert so the interior end is flush with the

heat shrink.

h. Fold the cloth shield or braid and drain wires over the clamping

insert and approximately 1/8 inch (3 mm) past the O-ring.

i. Install the gland body into the core processor housing conduit

opening.

5. Insert the wires through the gland body and assemble the gland by

tightening the gland nut.

6. Identify the wires in the 4-wire cable. The 4-wire cable supplied by

Micro Motion consists of one pair of 18 AWG (0,75 mm

) wires (red

and black), which should be used for the VDC connection, and one

pair of 22 AWG (0,35 mm

) wire (green and white), which should be

used for the RS-485 connection. Connect the four wires to the

numbered slots on the core processor, matching corresponding

numbered terminals on the transmitter. See Figure 12.

Shielded heat shrink completely covers exposed drain wires