Instruction manual

26 Micro Motion
®
Model D and DT Sensors Instruction Manual
Wiring continued
Power supply wiring to the
remote booster amplifier
• Remove screw and terminal cover before installing wiring. Re-install
cover before operating.
• Provide 85-250 VAC power to terminals L2 and L1 as shown in the
diagram below.
• This unit is provided with an external terminal for supplementary
bonding connections. This terminal is for use where local codes or
authorities permit or require such connections.
Remote booster amplifier power-supply wiring
Screw and terminal cover
Chassis ground
L/L
1
N/L
2
85-250 VAC
50/60 Hz
Supplementary bonding connection