Troubleshooting guide

73
Reference Manual
00809-0100-4308, Rev BA
Section 6: Service and Troubleshooting
December 2014
Service and Troubleshooting
Figure 6-1. Active Alerts Screens
Bandwidth Limited Configuration Warning Configuration Failure Electronics Warning
The device has not yet
received all of the
requested wireless
bandwidth needed to
operate as configured. See
“Wireless Network
troubleshooting” on
page 82 for recommended
actions.
The device has detected a
configuration error.
Non-critical operation of
the device may be
affected.
The device has detected a
configuration error. Critical
operation of the device
may be affected.
There is a warning which
should be addressed but
should not affect the
device output.
Electronics Failure Radio Failure Sensor Warning Sensor Failure
An electronics error that
could impact the device
measurement reading has
occurred.
The wireless radio has
detected a failure or
stopped communicating.
A sensor attached to the
transmitter is degraded.
Readings from that sensor
may not be within
accuracy specifications.
A sensor attached to the
transmitter has failed, and
valid readings from that
sensor are no longer
possible.
Supply Voltage Low Supply Voltage Failure
The voltage is below the
recommended operating
range. Replace the Power
Module, see “Power
module replacement” on
page 97.
The supply voltage is too
low and will affect device
operation. Replace the
Power Module, see “Power
module replacement” on
page 97.