Troubleshooting guide

65
Reference Manual
00809-0100-4308, Rev BA
Section 5: Operation
December 2014
Operation
Figure 5-1. Diagnostic Button Screen Sequence
1. Device Information: Tag 2. Device Serial Number 3. Software Revision
User entered tag which is 8
characters long. This screen
will not display if all
characters are blank.
Used to determine Device Serial
Number.
Used to determine Device
Software Revision.
4. Network ID 5. Network Connection Status 6. Active Alert Screens
(if present)
Used to determine the
entered Network ID in the
device.
The screen displayed is
dependent on the progress of
the device in joining the wireless
network. See Figure 4-8 on
page 54 for more information.
See “Device display alerts”
on page 72 for a full list of
Active Alerts that may
appear on this position of
the sequence.
7.Variable Screens 8. Active Alert Present
At the end of the sequence,
the device display shows all
selected variable screens.
This screen will only appear if
there is at least one Active Alert
present. For detailed
information of the failure source
and recommended actions, go
to the Active Alerts screen in
AMS
®
Wireless Configurator or
Field Communicator. Refer to
“Check Device Status” on
page 67.