Troubleshooting guide

62
Reference Manual
00809-0100-4308, Rev BA
Section 5: Operation
December 2014
Operation
Process leaks could result in death or serious injury.
Handle the transmitter carefully.
If the process seal is damaged, gas could escape from the tank when removing the
transmitter head from the probe.
Only qualified personnel should install the equipment.
Do not remove the transmitter while in operation.
To ensure long life for your radar transmitter, and to comply with hazardous location
installation requirements, tighten covers on both sides of the electronics housing.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: This device may not cause harmful interference. This device must accept any
interference received, including interference that may cause undesired operation. This
device must be installed to ensure a minimum antenna separation distance of 20 cm (8 in.)
from all persons.