Troubleshooting guide

52
Reference Manual
00809-0100-4308, Rev BA
Section 4: Configuration
December 2014
Configuration
4.5.4 Obtain Network ID and Join Key
In order to communicate with the Smart Wireless Gateway, and ultimately the host system, the
transmitter must be configured to communicate on the wireless network. This step is the
wireless equivalent of connecting wires from a transmitter to the host system.
The Network ID and Join Key may be obtained from the Smart Wireless Gateway's integrated
web interface on the Setup > Network > Settings page, as shown in Figure 4-7.
Figure 4-7. Gateway Network Settings
4.5.5 Enter Network ID and Join Key
The devices must be configured with the same Network ID and Join Key as the Gateway in order
to join the network. Use a Field Communicator or AMS Wireless Configurator to enter the
Network ID and Join Key so they match the Network ID and Join Key of the Gateway.
1. From the Home screen, select Configure.
2. Go to Guided Setup > Wireless Setup.
3. Click Join Device to Network, and follow the instructions.
If the device is not to be commissioned yet, remove the power module and fasten the housing
cover. This is to conserve power module life and to ensure safe transmitter transportation. The
power module should be inserted only when the device is ready to be commissioned.