Troubleshooting guide

51
Reference Manual
00809-0100-4308, Rev BA
Section 4: Configuration
December 2014
Configuration
4.5.3 Configure Update Rate
The Update Rate is the frequency at which a new measurement is transmitted over the wireless
network. The default update rate is 1 minute. This may be changed at commissioning, or at any
time via AMS Wireless Configurator or a Field Communicator. The Update Rate is user selectable
from 4 seconds to 60 minutes.
1. From the Home screen, select Configure.
2. Go to Guided Setup > Wireless Setup.
3. Click Configure Update Rate, and follow the instructions.
Note
Make sure to set the Update Rate so that there is enough safety margin in the system for
high/low alerts. If the time between each update is too long, the high/low alerts may be
triggered too late.
Run Check Level Response to make sure that configured Update Rate is sufficient for the
application, refer to section “Optional Setup” on page 58.